The processor model of Taipower P85 uses the latest ARM Cortex A8, and the operating system also uses the famous Android 2.3, so The powerful combination makes this Taipower P85 cast a shadow of "fast", "new" and "odd". The disadvantage of this tablet is that the memory is too small, only 1GB. If you want to run faster, you can only satisfy yourself by buying a memory card. Of course, no matter how good the configuration is, problems will inevitably occur. Sometimes a burned memory card may cause the Teclast P85 to face the challenge of disassembly.

Taipower P85 uses an 8-inch high-definition screen with a screen ratio of 4:3. The viewing area is 1.5 times that of an ordinary 7-inch 16:10 tablet! Whether browsing pictures, watching movies, browsing the web, or playing games, it has an excellent visual experience.

Disassembly steps:

1. Tools, "Utility Knife" according to the numbers above Pry open.

Second, before removing and inserting the battery, release the speaker wire first. You will need several toothpicks and a card.

Third, use a toothpick to pick apart the red-lined sticker. The toothpick is neither soft nor hard and will not damage the pattern line. In addition, it can be directly stuck on the sticky paper. On the paper, just take it off and reset it later and stick it on! If you want to remove and insert the battery below, you must remove the big battery, otherwise you can't pull out the plug (a cheating design). I heard that the battery is very soft and gravity will damage it. ​

4. Useless bank cards or preferential VIP cards are fine. Move slowly and insert them horizontally. When I went in, I saw some black spots on the battery in the picture. Be careful. I didn't know it at first, so I checked it out, but it was not damaged. It was a little wrinkled.

Five. After the battery is finished, there is foam glue on it, which just sticks to the card. You can use the card to access the battery. If it doesn't work, stick a card on it. If you hold the card between your fingers, the battery will be safe! I heard about the unplugging method Be careful, hard pulling will break it, use 2 toothpicks and a toothpick to dig it out at the same time, it is easy and simple!

Six. Don’t cover the box after finishing it. Arrange the wiring, move the red wire to the arrow position, or place it directly above the battery. In short, do not follow the "factory" wiring method. This is the culprit of the flickering screen.

Seven. The "flash screen" caused by being placed on that circuit board perfectly solves the problem.

Eight. Disassembly is completed.

Taipower P85 tablet After disassembly and repair, it can be deployed and used immediately. The WiFi function can also support 802.11b/g/n wireless normally, and the speaker will not be damaged in any way during disassembly. Of course, even if your Taipower P85 is used. If there is no damage, you can also check it through daily disassembly, but don’t wait until you are “ terminally ill” to worry about it. Because this product has a built-in microphone, routine inspection of the microphone is also very necessary. You must know that replacing accessories is very important. It's precious, and if it can't be repaired in time, it will be a "big deal".