Yuandao n50 is a domestic tablet computer. This tablet computer has good quality and is very affordable. It is just troublesome to carry. It can be used when traveling and at home. In addition, many people have said recently that they do not If you want to flash the original n50, you can only look at the new firmware and there is no other way. In response to this situation, the editor will introduce to you how to upgrade the original n50.

Yuandao n50 preparation tool

A computer, Yuandao n50, Yuandao N50 dedicated USB driver, Yuandao N Series upgrade tools, Yuandao N50 upgrade firmware image

Yuandao N50 flashing tutorial

The first step is to download the Yuandao N50 dedicated USB driver and related tools, and then unzip them for later use. .

The second step is to enter the settings of Yuandao N50, find the development in the application, and confirm whether USB debugging is checked. If not, check USB debugging.

The third step is to connect the original N50 to the computer using USB, and then browse to the pre-specified driver folder , and then click Confirm. If the Yuandao N50 has not installed any Android driver before, it will pop up a dialog box, and you can click OK in the dialog box.

The fourth step is to select the loading option. At this time, the computer will automatically install the driver software. The installation will be completed soon. At this time, a message called New Hardware Installed and Ready to Use will appear below the computer. prompt. In this way, the driver installation has been completed.

Step 5: Then open my computer. Two removable disk icons will appear in my computer. One is the flash built into the machine, and the other is the extended SD card. This We can't fight directlyOpen these two icons. If you open them directly, an error will occur. You need to go back to the N50 and open the USB storage before you can open those two icons.

The sixth step is to remove the USB cable, then close the original N50, and then open the original N50 system upgrade tool. Press and hold the "Volume +" button of the Yuandao N50, and then connect the USB cable. At this time, the computer will make a hardware connection sound, and the words on the tool will also change to "A LOADER device was found."

Step 7: Click on the firmware information to load the firmware. After loading, we need to choose to upgrade, and then wait for a few minutes, and the upgrade will be completed.

Here, the editor needs to give a warm reminder: after the computer firmware is loaded, the words "upgrade completed" will appear, and the original N50 will enter Go to engineering mode - automatic upgrade, in Do not remove the USB cable at this time. After the completion, the Yuandao N50 will automatically turn on and then automatically enter the screen calibration interface. After the automatic calibration is completed, you only need to click to confirm, so that the Yuandao N50 firmware will be completely upgraded. Got it!